Clamp

Clamps channel values so that they fit within a specified range. Clamping is performed for each channel individually, and out-of-range colours may be highlighted by setting them to a value different to the clamp threshold itself.

user

Container for user-defined plugs. Nodes should never make their own plugs here, so users are free to do as they wish.

out

The output image generated by this node.

enabled

Turns the node on and off.

in

The input image

channels

The names of the channels to operate on. Names should be separated by spaces and can use Gaffer’s standard wildcards.

min

The minimum value - values below this will be clamped if minEnabled is on.

max

The maximum value - values above this will be clamped if maxEnabled is on.

minClampTo

By default, values below the minimum value are clamped to the minimum value itself. If minClampToEnabled is on, they are instead set to this value. This can be useful for highlighting out-of-range values.

maxClampTo

By default, values above the maximum value are clamped to the maximum value itself. If maxClampToEnabled is on, they are instead set to this value. This can be useful for highlighting out-of-range values.

minEnabled

Turns on clamping for values below the min value.

maxEnabled

Turns on clamping for values above the max value.

minClampToEnabled

Turns on the effect of minClampTo, allowing out of range values to be highlighted.

maxClampToEnabled

Turns on the effect of maxClampTo, allowing out of range values to be highlighted.